Hitachi NV 83A5 Instrucciones Y Manual De Seguridad página 17

• By removing the lock pin as shown below, the tool
can be switched between SINGLE SEQUENTIAL
ACTUATION and CONTACT ACTUATION.
● When removing the lock pin, disconnect the
air hose from the tool and remove all nails.
● Please be warned that the once the lock
pin is removed, the SINGLE SEQUENTIAL
ACTUATION and CONTACT ACTUATION
switch function will be activated.
• Use a pair of pliers like the one shown below to
pull off the lock pin.
Lock Pin
CAUTION
● The lock pin should be discarded after removal.
(1) Intermittent operation (Trigger fi re)
Use the SINGLE SEQUENTIAL ACTUATION
MECHANISM setting.
● For intermittent operation, set the change
Rod as shown in the fi gure below. (i.e.
Set to SINGLE SEQUENTIAL ACTUATION
MECHANISM.)
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Set the switching device to SINGLE
SEQUENTIAL ACTUATION MECHANISM.
2) Pull the trigger rapidly and fi rmly.
1 Follow the steps below to set up the SINGLE
SEQUENTIAL ACTUATION MECHANISM (as
shown in the diagrams that follow).
● Disconnect the air hose and remove all nails.
● Do not depress the push lever.
WARNING
WARNING
WARNING
● Do not apply any unnecessary pressure or
use any tools to move the switch.
● Do not press the change stopper for any
other purpose other than to switch between
SINGLE SEQUENTIAL
CONTACT ACTUATION.
1) If the lock pin is left, skip 2) through 3) and
proceed from 4).
2) Press the bottom of the trigger and open the
change stopper.
3) Grasp the change rod between two fi ngers
and slide it downwards.
(Sets the SINGLE SEQUENTIAL ACTUATION
MECHANISM)
4) Make sure that the change rod is in its proper
position as shown in the diagram.
(If not, the tool may be set in the CONTACT
ACTUATION MECHANISM.)
2 Position the nail outlet on the workpiece with
fi nger off the trigger.
3 Depress the push lever fi rmly until it is completely
depressed.
4 Pull the trigger to drive a nail.
5 Remove fi nger from the trigger.
To continue nailing in a separate location, move the nailer
along the wood, repeating steps 2 – 5 as required.
1
3
English
ACTUATION
Position of
Change Rod
Trigger
4
Push Lever
and
17