Tripp-Lite SU40K El Manual Del Propietario página 14

6 – Internal Battery Connection
1
6-2 Internal Battery Connection Procedure
• Slide a battery string with a red cable into an empty slot within
6
2
the battery compartment. Make sure the battery string is oriented
as shown in the diagram. Note: Start with the empty slots at the
bottom of the battery compartment and work toward the empty
slots at the top of the battery compartment.
3
4
• 7 Slide a battery string with a black cable into an empty slot within
the battery compartment, next to the battery string that you inserted
5
in step 6. Make sure the battery string is oriented as shown in the
diagram. Repeat steps 6 and 7 as needed until all the battery strings
have been inserted into the empty battery slots.
6
7
• 8 Reconnect the fuse block bracket. (The letters on the fuse block
bracket should be upright when it is in the correct orientation.)
8
9
• 9 Connect the blue and white jumper cables on each internal battery
10
pack to the corresponding fuse block. The labeling next to the fuse
block identifies the correct fuse block for each cable.
11
12
10
• Insert the battery cartridge fuses into each fuse block. The fuses are
interchangeable. Make sure the fuses are firmly snapped into place.
Warning: Battery cartridge fuses must be inserted last due to
potential arcing of connectors. Blown fuses must be replaced
by a qualified electrician. Replace only with fuses of the same
13
type and rating.
14
(continued)
(contiinued)
TERMINALS
SIDE VIEW
6
TERMINALS
SIDE VIEW
7
8
9
10
14