Optional Accessories; Stacking Kit Installation - LG Df20WV Manual Del Usuario

48
OPTiONAL ACESOriES

OPTIONAL ACCESSORIES

Stacking kit installation

this stacking kit includes:
• Two (2) side rails
• One (1) front rail
• Four (4) screws
tools needed for Installation:
• Phillips screwdriver
To ensure safe and secure installation, please observe
the following instructions.
WArNiNg
w
• Incorrect installation can cause serious accidents.
• The weight of the dryer and the height of
installation make this stacking procedure too risky
for one person. Two or more people are required
when installing the stacking kit. There is a risk of
serious back injury or other injuries.
• Do not use the stacking kit with a gas dryer in
potentially unstable conditions such as a mobile
home. Failure to follow this warning can result in
serious injury.
• Place the washer on a solid, stable, level floor
capable of supporting the weight of both
appliances. Failure to follow this warning can result in
serious injury.
• Do NOT stack the washer on top of the dryer. Failure
to follow this warning can result in serious injury.
• If appliances are already installed, disconnect them
from all power, water, or gas lines and from draining
or venting connections. Failure to do so can result in
electrical shock, fire, explosion, or death.
• Wear gloves during installation
1. Make sure the surface of the washer is clean and dry.
Remove paper backing from the tape on one of the
stacking kit side brackets.
2. Fit the side bracket to the side of the washer top
as shown in the below illustration. Firmly press the
adhesive area of the bracket to the washer surface.
Secure the side bracket to the washer with a screw on
the back side of the bracket. Repeat steps 1 and 2 to
attach the other side bracket.