Caution On Lithium-Ion Battery - Hitachi WH14DL Instrucciones De Manejo

11. Do not use the charger continuously.
When one charging is completed, leave the charger
for about 15 minutes before the next charging of
battery.
12. Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
13. Never disassemble the rechargeable battery and
charger.
14. Never short-circuit the rechargeable battery.
Short-circuiting the battery will cause a great
electric current and overheat. It results in burn or
damage to the battery.
15. Do not dispose of the battery in fire.
If the battery burnt, it may explode.
16. Do not insert object into the air ventilation slots
of the charger.
Inserting metal objects or inflammables into the
charger air ventilation slots will result in electrical
shock hazard or damaged charger.
17. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery
life becomes too short for practical use. Do not
dispose of the exhausted battery.
18. Using an exhausted battery will damage the
charger.
SPECIFICATIONS
Cordless Impact Driver
Model
Voltage
No-Load speed
Capacity (Ordinary bolt)
Tightening torque (Maximum)
Rechargeable battery
Weight
Cordless Impact Wrench
Model
Voltage
No-Load speed
Capacity (Ordinary bolt)
Tightening torque (Maximum)
Rechargeable battery
Weight
Charger
Model
Charging voltage
Charging time 3.0 Ah
Weight
Charge time is approximate. Actual charge time may
vary.

CAUTION ON LITHIUM-ION BATTERY

To extend the lifetime, the lithium-ion battery equips
with the protection function to stop the output.
In the cases of 1 and 2 described below, when using
this product, even if you are pulling the switch, the
motor may stop. This is not the trouble but the result
of protection function.
1.
2.
WH14DL
14.4 V
140 N·m
EBL1430: Li-ion (4 cells)
3.0 Ah
BCL1430: Li-ion (4 or 8 cells)
1.5 kg
WR14DL
14.4 V
200 N·m
EBL1430: Li-ion (4 cells)
3.0 Ah
BCL1430: Li-ion (4 or 8 cells)
1.5 kg
UC18YRL
7.2 – 18 V
45 min.
0.6 kg
When the battery power remaining runs out (The
battery voltage drops to about 12V (WH18DL,
WR18DL) / about 8V (WH14DL, WR14DL)), the
motor stops.
In such case, charge it up immediately.
If the tool is overloaded, the motor may stop. In
this case, release the switch of tool and eliminate
causes of overloading. After that, you can use it
again.
-1
0 – 2600 min
M6 – M14
EBM1830: Li-ion (10 cells)
-1
0 – 2600 min
M10 – M16
EBM1830: Li-ion (10 cells)
English
WH18DL
18 V
150 N·m
1.6 kg
WR18DL
18 V
220 N·m
1.6 kg
6