Furius FIX 181 MINI Manual De Instrucciones página 39

Bonded electrode (ANTI STICK)
If the electrode does not ignite, or the arc goes out while the electrode is being welded, it may stick
to the part to be welded. This situation is detected by the electronic board of the equipment and
the welding current is automatically reduced. This allows you to free the stuck electrode from the
surface to be welded by moving it back and forth.
While the electrode is attached, the warning indicator lights up
electrode holder and the ground is indicated in the same way. If the electrode cannot be detached,
remove the electrode holder and remove it manually using the appropriate protection and
tweezers. Be careful as the electrode can be very hot.
Duty cycle excess protection or thermal control device.
When there is protection by reaching the maximum duty cycle, or by internal heating of the
machine, the arc is extinguished and the LED
illuminated, while the welder cools down to continue its normal operation. Do not turn off the
welder, allow the fans of the equipment to cool the machine's power components until the LED
light turns off. Only until this moment can the machine be switched off or start welding again.
Note: to preserve the power components of the welding machine from heat accumulation, do not
disconnect it immediately after activation of the protection, as described above.
. A short circuit between the
that identifies protection of the machine is
17