Connection For Tig - Furius FIX 181 MINI Manual De Instrucciones

Connection for TIG

10.
To use TIG with the Furius FIX 181 MINI connect the torch to the negative socket or connector of the machine
and the work clamp (ground) to the positive socket or connector of the machine, as shown in the following
figure:
Argon gas from a cylinder with a flow regulator must be used for this gas. The torch must be
connected directly to the regulator. The equipment does not have an electrovalve to control the
gas flow, so the use of a torch with a knob is recommended for regulation and interruption of gas
flow. It is recommended to adjust a gas flow of 10 to 20 l / m or 21 to 40 CFH.
The arc start mode in TIG is scratch, which means that to start the arc it is necessary to scratch the
tungsten electrode against the piece and separate it, as shown in the following images:
1. PLACE THE TORCH IN POSITION
2. SLIGHTLY SCRATCH THE TUNGSTEN
AGAINST THE WORKPIECE
3. SEPARATE THE TUNGSTEN
FROM 2 TO 4 MM TO START THE
ARC
18