Operating Instructions - Tribest SEDONA COMBO SD-P9150 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS

For your safety and to protect your Tribest Sedona Combo, please follow the instructions
below:
1. Always keep the Tribest Sedona Combo on a level surface.
• Keep the Tribest Sedona Combo at least 10 cm away from walls, other appliances or furniture.
2. Open the door to insert trays into the Tribest Sedona Combo. Hold the tray in the horizontal
position and push the tray into the proper slots.
• Place the food evenly and neatly on each tray as close as possible (remember dehydrating
removes water and/or shrinks food). For best results, cut the food into even sizes and thickness.
• It is recommended to use separate trays for each type of food.
• You may dehydrate up to 9 trays simultaneously.
• For 4-5 trays of dehydrated recipes, use the upper compartment for best results. The white
plastic dividers on the side of the Sedona Combo now help as a simple visual device to
separate upper and lower compartments.
• Double check whether all the trays are properly loaded.
3. Plug into an outlet that has 10-amp capacity.
4. Turn the main switch ON.
5. There are three settings to choose with the Sedona Combo:
• TWO-STAGE SEQUENTIAL TEMPERATURE-TIMER (TST) Use Only
The Two-Stage Sequential Temperature-Timer (TST), a two-phase combo mode that allows for both
FAST mode and RAW mode to be applied sequentially. This is the default setting of the Sedona
Combo when it is turned on.
1) Turn the Sedona Combo on, both the RED and GREEN lights to the right of the MODE button
will be lit. (Red=FAST mode, Green=RAW mode.)
2) Press the °F/°C button to choose Fahrenheit or Celsius.
3) Press the SET button to set FAST mode to your desired temperature using the UP/DOWN 10
or 1 buttons.
4) Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for FAST mode.
5) Press SET again to set the desired temperature using the UP/DOWN 10 or 1 buttons for RAW
mode.
6) Press SET again to set the desired time using the UP/DOWN 10 or 1 buttons for RAW mode.
7) Press SET to finalize settings.
8) Press the TRAY button to choose the upper, lower, or both drying compartments.
9) Press the START/PAUSE button to begin operation.
NOTE: During TST mode operation, the upper RED light blinks while the Sedona Combo first
operates at the higher temperature for the set amount of time; and then, the lower GREEN
light blinks, when the temperature automatically lowered to the second setting for the remaining
dehydrating time.
• FAST Mode Use Only
This setting holds and maintains a higher temperature (e.g. 155°F) for faster dehydrating. The
temperature in the dehydration chamber may fluctuate above and below the set temperature as the
heating elements cycle on and off.
1) Set the Sedona Combo to FAST mode by pressing the MODE button once to change the
default Two-Stage Sequential Temperature-Timer (TST) to FAST mode. (A RED light lit to the
upper right of the MODE button indicates that the Sedona Combo is set at FAST mode.)
14

Publicidad

Tabla de contenido
loading

Tabla de contenido