Bosch NGM30 Instrucciones De Conversión página 6

position inserting it into the indent in the metal cap.The
stem should snap into place.
Natural
Gas
Important - Attach the metallic sticker (included with this
conversion kit) to the bottom of the appliance as shown,
placing it near the appliance data plate (shows model
number and information about the appliance). This sticker
provides notice that the appliance has been converted for
use with LP gas
.
bottom of cooktop
Step 2 - Replace the Orifices
1. Remove the grates and burner caps.
Note:Do not remove the ignitor from the unit.
2. Remove the orifices.
Note: The orifices require a 7 mm socket driver for
removal/replacement. The driver will need to be
inserted approximately 2 1/2" (64 mm) into the
burner cavity to reach the orifice.
Hint: To reduce the chance of the orifice being dropped
from the socket driver, add a piece of foam tape or
adhesive tape inside the socket.
a) Trim a small piece of the foam tape provided with
this kit (about 1/4" x 1/2"; 6mm x 12mm).
b) Fit this so the tape wraps against one side of the
socket so it stays in place.
c) When pressing the socket driver onto the orifice,
the tape will fit to the orifice and help prevent the
orifice from falling out of the socket during
extraction.
English 4
LP
Gas
Save the NG orifices in case there is need later to restore
the appliance to use natural gas again.
4. Identify the correct placement of the LP gas orifices as
layed out on the orifice package card.
Note: The NGMP055UC and NGMP655UC models
have an extra hidden orifice underneath the center unit
cap. It is necessary to remove the burner cover plate to
change the hidden (smaller) center orifice.
smaller
center
orifice
The orifice sizes are shown in the white circles
corresponding to each burner as shown in the image
below. These numbers are engraved on the top of each
orifice. It is very important install the correct orifice size
for each burner.