Maintenance - EGO Power+ LM2100SP Manual Del Usuario

Cortadora inalámbrica de iones de litio de 56 voltios
Ocultar thumbs Ver también para Power+ LM2100SP:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE

WARNING: To avoid serious personal injury, always remove the battery pack from the mower before cleaning or
performing any maintenance.
WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or
cause product damage. To ensure safety and reliability, all repairs should be performed by a qualified service technician.
CLEANING THE MOWER
WARNING: Always remove the battery pack when servicing or transporting the mower.
The underside of mower deck should be cleaned after each use, as grass clippings, leaves, dirt and other debris will
accumulate. This accumulation is undesirable, as it will promote rust and corrosion.
Remove any build-up of grass and leaves on or around the drive shaft (only LM2100SP) and motor fan (do not use water).
Wipe the mower clean with a damp cloth.
REMOVING THE BLADE
WARNING: Always protect your hands by wearing heavy
gloves or wrapping the cutting edges with rags or other materials
when performing any maintenance on the mower blade. Always
remove the battery pack when servicing or transporting the
mower.
NOTICE: The following tools are required for replacing the blade:
◾ ◾
9/16" (14mm) wrench
◾ ◾
torque wrench
◾ ◾
Manual screwdriver or metal rod with a diameter of
5/16" (8mm)
◾ ◾
Manual screwdriver or metal rod with a diameter 1/4" of
(6.35mm) or less.
1. Stop the motor; remove the battery pack from the mower.
2. Turn the mower on its side.
3. While wearing protective gloves, place a metal rod (e.g., a
3.5" length screw bit) with diameter less than 5/16" (8mm)
into the fixing hole to act as a stabilizer (Fig. 22).
4. Use a 9/16 inch (14mm) wrench to turn the blade bolt
counterclockwise to loosen it.
NOTICE: If the bolt rotates with the motor shaft when loosening
the bolt, turn the fan by hand to align the through holes in the fan
with the holes in the blade, and place another metal rod (e.g., a
3.5" length screw bit) with diameter less than 1/4 inch (6.35mm)
into the aligned holes to act as another stabilizer (Fig. 23).
Continue using the 9/16 inch (14mm) wrench to turn the
5.
blade bolt counterclockwise to loosen it completely.
22
23
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP & LM2100
Stabilizer
Loosen
Stabilizer 1
Stabilizer 2
Loosen
25

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Power+ lm2100

Tabla de contenido