EGO Power+ LM2100SP Manual Del Usuario página 31

REPLACING THE TRAILING SHIELD
WARNING: Always remove the battery pack when servicing
or transporting the mower.
WARNING: Never operate the mower unless the trailing
shield is in place and working. Never operate the mower with
damaged safety devices. Failure to do so can result in personal
injury. The trailing shield is subject to wear and damage, which
could expose moving parts or allow objects to be thrown. For
safety protection, frequently check the trailing shield and replace
it immediately with only the identical replacement part, listed in
this manual.
1. Remove the battery
2. Turn the mower on its side with the upper surface against
a wall.
3. Remove the rear wheel on the top side, following the
section "REPLACING THE WHEELS" in this manual.
4. For self propel mower LM2100SP, loosen the wheel cover
locking screw and remove the screw, spring washer and
flat washer in that order, then remove the wheel cover from
the wheel shaft (Fig. 34).
5. Repeat steps 1 to 3 above the remove the other rear wheel
and wheel cover (LM2100SP only).
6. Loosen the locking screw for the trailing shield on both
sides; remove the worn trailing shield (Fig. 35a & 35b).
34
35a
35b
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP & LM2100
Wheel Cover
Wheel Axle
Locking Screw
Locking Screw For
Trailing Shield
For LM2100SP
Locking Screw For
Trailing Shield
Trailing shield
For LM2100
Trailing shield
31