6.1 Manual mode
To manually activate a fog output, press the green but-
ton MANUAL (16): While this button is kept pressed,
the unit will emit the maximum quantity of fog.
The manual mode will take priority over the continuous
mode and the timer mode, i. e. when the green button
is pressed, the unit will always emit the maximum
quantity of fog even if one of the other operating
modes is activated.
6.2 Continuous mode
In the continuous mode, the unit will emit fog continu-
ously.
1) To activate the continuous mode, press the red but-
ton CONT (15) so that it will engage and the red
LED (11) above the button will light up.
2) With the control VOLUME (13), adjust the fog out-
put quantity from 0 – 100 %.
3) To deactivate the continuous mode, disengage the
red button.
The continuous mode will take priority over the timer
mode, i. e. when the red button is pressed, the unit is
set to continuous mode even if the timer mode is acti-
vated with the button TIMER (12).
6.3 Timer mode
In the timer mode, the fog machine will automatically
emit fog in adjustable intervals of 5 to 140 seconds.
The fog times are just as long as the pauses.
1) To activate the timer mode, press the yellow button
TIMER (12) so that it will engage and the yellow
LED (10) above the button will light up.
2) With the control INTERVAL (9), adjust the intervals
between the individual fog outputs.
3) With the control VOLUME (13), adjust the fog out-
put quantity from 0 – 100 %.
4) To deactivate the timer mode, disengage the yellow
button; the LED above it will be extinguished.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
®
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
7 Cleaning
For cleaning the outside of the unit, only use a dry, soft
cloth; never use chemicals or water which may get
inside the unit.
Due to the viscosity of the fog fluid and the high
vaporizing temperature, fog machines are susceptible
to clogging. After approx. 40 hours of operation, it is
therefore recommended to clean the unit with a fluid
consisting of 80 % distilled water and 20 % vinegar.
1) Disconnect the fog machine from the mains and
allow it to cool down sufficiently.
2) Completely empty the tank.
3) Fill the tank with the cleaning fluid.
4) Operate the unit with the cleaning fluid in a suffi-
ciently ventilated environment until the tank is
empty.
5) Refill the unit with fog fluid and create fog for
approx. 3 minutes to remove any acid residues from
the unit.
8 Specifications
Heating power: . . . . . . . . . . . 850 W
Heat-up time: . . . . . . . . . . . . approx. 4 minutes
Tank capacity: . . . . . . . . . . . 1.2 litres
Fog output: . . . . . . . . . . . . . . approx. 450 m
Power supply: . . . . . . . . . . . 230 V~/50 Hz
Power consumption: . . . . . . 900 VA
Dimensions (W × H × D): . . . 205 × 270 × 420 mm
Weight: . . . . . . . . . . . . . . . . . 4.1 kg
Subject to technical modification.
3
per minute
GB
9