Publicidad
Idiomas disponibles
Idiomas disponibles
BV 9650
Before first and after each use, clean it following these instructions.
Jar, lid and tamper cleaning
1. Remove the plug from the wall outlet.
2. Remove the jar from the blender base and empty the jar. Rinse the inside with warm water.
3. Then add 2 drops of liquid dishwashing soap and 1L of warm water to the jar.
4. Lock the cap into the lid and push the lid tightly onto the jar. Place the jar on the base.
5. With ON/OFF switch in OFF position, plug the blender.
6. Rotate the speed control to the lowest setting, place ON/OFF switch in ON position and increase the
speed slowly to maximum. Keep the high speed for 30-60 seconds.
7. Switch off the blender and unplug it.
8. Remove the jar from the base, empty and rinse it with clear water to remove all the soap from the jar.
9. Wipe the base with a damp cloth. If necessary, you can use a little mild detergent on the cloth.
10. Clean the tamper, lid and cap with warm soapy water.
11. Dry the jar and the other accessories with a soft cloth, place on the base and you can save it.
WARNING: use extreme caution when handling the jar, the blades are very sharp.
Base cleaning
1. Unplug from the wall outlet. Wipe exterior housing with soft damp soapy cloth. Take care any liquid
enters to interior of motor. Never use stiff brushes or abrasive cleaners.
2. Lift the centering platform off the base and wash it in warm soapy water. Rinse and dry.
3. When the switches become sticky, clean them with a cotton swab dampened with mild liquid detergent.
Dry them immediately.
Blades cleaning
1. Remove the blades with provided tool. Snap the
hooks into the nut's holes; hold the jar with the other
hand and turn the nut clockwise with the tool.
2. Grasp the blades carefully, they are very sharp. Clean
them and put them back into position.
3. Tighten the nut with the tool turning to the left.
Make sure that it is tightly tightened to prevent the
blades dismounting and that the jar loses liquid.
16
Publicidad
