Hama 00040072 Instrucciones De Uso página 7

Note:
Setting the search speed
• The default setting for the search time per code is
1 second. If this does not suit you, you can change
to a search time of 3 seconds per code. To switch
between search times, press "CH+" or "CH-" within
the 6 seconds before the automatic code search
starts.
5.3.5 The LED confirms the respective code searches
with a single flash.
5.3.6 As soon as the device to be operated shows a
response, press the "MUTE" button to save the
code and exit the code search. The LED goes out.
5.3.7 Then test the remote control and check whether
the desired functions can be controlled. It is
possible that the first code found is not the
most suitable, and possibly not all functions are
available. In this case, repeat steps 5.3.1. – 5.3.6.
The code search starts with the next code
following the last one saved.
5.3.8 To cancel the automatic search during the search
process, press the "EXIT" button.
Note
• If all codes have been searched without success,
the universal remote control exits the automatic
code search and automatically returns to
operating mode. The currently stored code remains
unchanged.
5.4 Code recognition
Code recognition offers you the ability to determine a
code you have already saved.
5.4.1 Press the "SETUP" button until the LED lights up
continuously.
5.4.2 Use the device button to select the device to be
operated (e.g. TV). If the selection is successful,
the LED flashes once and then lights up
permanently.
5.4.3 Press the "SETUP" button. The LED flashes once
and then lights up permanently.
5.4.4 Press one of the number buttons from 0 to 9 to
search for the first digit. The LED flashes once for
the first digit of the four-digit code number.
5.4.5 Repeat step 5.4.4 for the second, third and fourth
digits respectively.
5.4.6 You can then enter the determined code in the
table below if you need it again at a later time
(e.g. after accidentally deleting the remote control
settings).
TV
6. Special functions
6.1 Channel punch-through
With the channel punch-through function, the CH+
or CH- commands can bypass the currently controlled
device and change the channels of a second device. All
other commands are unaffected.
To activate the channel punch-through function:
• Press the desired device button (e.g. TV).
• Press and hold the "CH+" button.
• Press the desired device button (e.g. STB).
• Release the "CH+" button again (the LED ashes once
when the setting is activated).
To deactivate the channel punch-through function:
• Press the desired device button (e.g. TV).
• Press and hold the "CH-" button.
• Press the desired device button (e.g. STB).
• Release the "CH-" button again (the LED ashes twice
when the setting is deactivated).
CODES
STB
9