Direct Code Entry - Hama 00040072 Instrucciones De Uso

Warning - Batteries
• Remove the batteries from products that are not
being used for an extended period (unless these are
being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain
toxic, environmentally harmful heavy metals.
• Remove spent batteries from the product and
dispose of them without delay.
• Avoid storing, charging and using in extreme
temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
4. First steps - Inserting the batteries
Note
• Alkaline batteries are recommended. Use two
batteries of the type "AA" (LR6/Mignon).
• Remove the battery cover on the back of the
universal remote control (A).
• Insert the batteries, observing the "+/-" marks for
polarity (B).
• Close the battery compartment (C).
Note: Code memory
• This remote control saves the settings even during
a battery change.
Note: Energy saving function
• The remote control switches itself off automatically
if a button is pressed for longer than 15 seconds.
This prolongs the life of the batteries if the remote
control is stuck in a place where the buttons are
pressed permanently, e.g. between sofa cushions.
5. Setup
Note
• For proper infra-red transmission, always hold the
remote control in the approximate direction of the
device to be operated.
• If no entry is made within 30 seconds, SETUP mode
is automatically terminated. The LED ashes six
times and then goes out.
• You cannot operate a device with the universal
remote control while it is in Setup mode. Exit Setup
mode and select the device to be operated using
the device selection buttons.
• Please note that the remote control emits infra-red
signals. These are not visible to the human eye.

5.1 Direct code entry

A code list is included in the universal remote control's
extent of delivery. The code list contains four-digit codes
for setting the remote control to work with most TV/STB
equipment manufacturers.
For easy orientation, the codes are sorted rst by
type of device (TV, STB) and within the type of device
alphabetically by brand name.
7