Important Safety Instructions; Appliance Handling Safety; Safety Codes And Standards; Electric Safety - Gaggenau DV 463 710 Instrucciones De Instalación

9 IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
9 WARNING
R E A D A N D S A V E T H E S E I N S T R U C T I O N S
If the information in this manual is
not followed exactly, fire or shock
may result causing property damage
or personal injury.
9
WARNING
Do not repair, replace or remove any
part of the appliance unless
specifically recommended in the
manuals. Improper installation,
service or maintenance can cause
injury or property damage. Refer to
this manual for guidance. All other
servicing should be done by an
authorized servicer.

Appliance Handling Safety

Hidden surfaces may have sharp
edges. Use caution when
reaching behind or under
appliance.

Safety Codes and Standards

This appliance complies with the latest
version of one or more of the following
standards:
UL 963- Sealing, Wrapping, and
▯
Marking Equipment
CSA C22.2 No. 64 - Household
▯
Cooking and Liquid-Heating
Appliances
It is the responsibility of the owner and
the installer to determine if additional
requirements and/or standards apply to
specific installations.

Electric Safety

9 WARNING
Before you plug in an electrical cord
or turn on power supply, make sure
all controls are in the OFF position.
For appliances equipped with a cord and
plug, do not cut or remove the ground
prong. It must be plugged into a matching
grounding type receptacle to avoid
electrical shock. If there is any doubt as
to whether the wall receptacle is properly
grounded, the customer should have it
checked by a qualified electrician.
If required by the National Electrical
Code (or Canadian Electrical Code), this
appliance must be installed on a separate
branch circuit.
Installer – show the owner the location of
the circuit breaker or fuse. Mark it for
easy reference.
INSTALLER: LEAVE THESE
INSTRUCTIONS WITH THE APPLIANCE
AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE THESE
INSTRUCTIONS FOR THE LOCAL
ELECTRICAL INSPECTOR'S USE.
Before installing, turn power OFF at the
service panel. Lock service panel to
prevent power from being turned ON
accidentally.
Refer to data plate for more information.
See "Data Plate" under "Service" for data
plate location.
3