Stopping The Mower; Basic Maintenance Made Easy - IKRA IBRM 1446 TL Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
• To start the engine from cold, move the throttle control
lever to its most forward position labelled START, as
shown in fig. 11.
• To start a warm engine, move the throttle control lever
to the RUN position as shown in fig. 12.
• Stand behind the handlebars. Move the operator
control lever positioned in front of the handlebars
rearwards so that the lever is resting against the han-
dlebars (fig.14). Take hold of the starter handle firmly
with the other hand.
• Pull back the starter until you feel resistance and then
pull the handle firmly and briskly to turn the engine
(fig. 14).
• Repeat the above procedure as necessary until the
engine starts.
• When starting from cold, gradually move the throt-
tle lever to the full throttle position RUN after a few
moments of running. It is now ready to start mowing.
• To turn off your mower, slide the throttle control lever
down to the STOP position. See fig. 13. In emergency,
directly release the operator control lever to stop the
engine as fig.16.
WARNING: The cutting blade turns when the en-
gine is being started.
11
13
Mowing your lawn
Start your mower (see: starting the engine). Keep hold of
the Brake (OPC) Lever (see fig.15) (releasing the Brake
(OPC) Lever will stop the engine to avoid accidents) (fig
16). To power the mower forward, move the Drive Lever
up and forward (fig.17). The Mower can be pushed with
the drive disengaged for more precise handling. After
mowing and emptying the Grass Catcher ensure the
engine it not running and turned off.
GB | Operating Instructions
12
14
15
17

Stopping the mower

To stop the mower, release the operator control lever.
The engine and the blade will stop turning automatically.
If there is a build-up of grass beneath the chassis, stop
the engine, remove the spark plug cap and wait until the
engine has cooled before clearing the grass.
When the engine has been switched off, the cutter
continues running for several seconds therefore do
not touch the underside of the mower until the cutter
has come to a standstill!

Basic maintenance made easy

WARNING! If your mower is not serviced correctly,
you reduce your mower's ability to operate and
void warranty.
Maintenance schedule
Each use 25hours
Air filter Check
Spark
Check
plug
Engine
Check
oil
9
16
50hours
100 hours
of use
of use
of use
Clean
Clean
Replace
Check
Clean
Replace
Check
Replace
Replace

Publicidad

Tabla de contenido
loading

Tabla de contenido