Safety Notes; General Notes; Functions - marklin Köf III Serie Manual De Instrucciones

Safety Notes

• This locomotive is to be used only with an operating sys-
tem designed for it (Märklin AC, Märklin Delta, Märklin
Digital or Märklin Systems).
• Use only switched mode power supply units and trans-
formers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one transformer.
• Pay close attention to the safety notes in the instructions
for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
74046 interference suppression set is to be used for this
purpose.
• WARNING! Sharp edges and points required for operati-
on.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.

General Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Märklin dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
8

Functions

• Recognition of the mode of operation: automatic.
• Addresses that can be set: 01 – 80
1-80 (Control Unit 6021/Mobile Station 60651/652)
1-255 (Central Station 60xxx/Mobile Station 60653)
• Address set at the factory: 23
• Mfx technology for the Mobile Station/Central Station.
Name set at the factory: BR 335 234-1
• Adjustable acceleration (ABV).
• Adjustable Braking delay (ABV).
• Adjustable maximum speed.
• Setting the locomotive parameters (address, accelerati-
on/braking delay, maximum speed): with the Control Unit,
Mobile Station, Central Station.
• Headlights, changing over with the direction of travel.
• Telex coupler (remote controlled uncoupler unit)
• Only the train control functions and headlight changeo-
ver feature are available in analog operation.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Märklin have been installed
in Märklin products or where Märklin products have been converted in
such a way that the non-Märklin parts or the conversion were causal to
the defects and/or damage arising. The burden of presenting evidence
and the burden of proof thereof, that the installation of non-Märklin parts
or the conversion in or of Märklin products was not causal to the defects
and/or damage arising, is borne by the person and/or company responsi-
ble for the installation and/or conversion, or by the customer.