Operation - Zenoah GZ360 Manual De Usuario

7. The saw chain is tightened correctly as it does not
sag from the below the guide bar, but you can turn it
easily by hand. Hold up the guide bar tip and tighten
the bar nuts with the combination spanner.
8. Do a check of the chain tension frequently, after you
have assembled a new saw chain, until the saw
chain is run-in.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
WARNING: The start/stop switch
automatically returns to run position. In order
to prevent unintentional starting, the spark
plug cap must be removed from the spark
plug when assembling, checking and/or
performing maintenance.
WARNING: Always wear personal protective
equipment. See header
equipment on page 5
To do a function check before you use
the product
1. Do a check of the chain brake to make sure that it
operates correctly and that it is not damaged.
2. Do a check of the rear right hand guard to make sure
that it is not damaged.
3. Do a check of the throttle lockout to make sure that it
operates correctly and that it is not damaged.
4. Do a check of the start/stop switch to make sure that
it operates correctly and that it is not damaged.
5. Make sure that there is no oil on the handles.
6. Do a check of the anti vibration system to make sure
that it operates correctly and that it is not damaged.
7. Do a check of the muffler to make sure that it is
correctly attached and that it is not damaged.
8. Do a check of the chain saw to make sure that all
parts are correctly attached and not damaged or
missing.
9. Do a check of the chain catcher to make sure that it
is attached correctly.
321 - 004 - 27.09.2017

Operation

Personal protective
9. Do a check of the chain tension regularly. A correct
chain tension results in good cutting performance
and a long life.
To assemble a spiked bumper
To assemble a spiked bumper, consult your servicing
dealer.
10. Do a check of the chain tension.
3
4
6,8
2
Fuel
This product have a two-stroke engine and must always
run on a mixture of gasoline and two-stroke oil.
Gasoline
• Use unleaded or leaded gasoline of a good quality.
• The lowest recommended octane grade is 90 (RON).
There is a risk that use of lower grade causes
knocking. This gives rise to a high engine
temperature and increased bearing load, which
results in serious engine damages.
• We recommend a higher octane when you do work
with continuous high revs, for example when you use
the limbing technique.
Ethanol fuel
Zenoah recommends commercial available fuel with
maximum 10% ethanol contents.
Running-in
Do not run the engine at unloaded full throttle for
extended periods during the first 10 hours.
Two-stroke oil
• For best results and performance use Zenoah two-
stroke oil, which is specially formulated for our two-
stroke engines. Mixture 1:50 (2%).
• If Zenoah two-stroke oil is not available, use a
different two-stroke oil of good quality that is
10
7
1 9
13