Pioneer SX-S30 Manual De Instrucciones página 34

> Before Start > Part Names
∫ Distance
Set the distance from each speaker to the listening position.
Front Left Specify the distance between each speaker and the listening
position. (Default Value is "10.0ft/3.00m")
Front Right Specify the distance between each speaker and the listening
position. (Default Value is "10.0ft/3.00m")
Subwoofer Specify the distance between each speaker and the listening
position. (Default Value is "10.0ft/3.00m")
0 Default values vary depending on the regions.
0 Distance units can be switched by pressing MODE on the remote controller. When the
unit is set as feet, you can set between 0.1 ft and 30.0 ft in increments of 0.1ft. When the
unit is set as meters, you can set between 0.03 m and 9.00 m in increments of 0.03 m.
∫ Channel Level
Front Left Select a value between "-12 dB" and "+12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Front Right Select a value between "-12 dB" and "+12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
Subwoofer Select a value between "-15 dB" and "+12 dB" (in 1 dB
increments). A test tone will be output each time you change the
value. Select the desired level (Default Value is "0 dB").
> Install > Initial Setup > Playback
Audio Adjust
∫ Dual Mono/Mono
Dual Mono Set the audio channel or language to be output when playing
multiplex audio or multilingual TV broadcasts etc.
"Main (Default Value)": Main channel only
"Sub": Sub channel only
"Main / Sub": Main and sub channels will be output at the same
time.
0 If multiplex audio is being played, "1+1" will be displayed on
the display of this unit when
pressed.
Mono Input Channel Set the input channel to use for playing any 2 ch digital source
such as Dolby Digital, or 2 ch analog/PCM source in the Mono
listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right (Default Value)": Left and right channels
∫ Dolby
Loudness When playing Dolby TrueHD, enable the dialog normalization
Management function which keeps the volume of dialog at a certain level. Note
that when this setting is Off, the DRC function that allows you to
enjoy surround at low volumes is fixed to off when playing Dolby
Digital Plus/Dolby TrueHD.
"On (Default Value)": Use this function
"Off": Do not use this function
∫ Volume
Volume Limit Set the maximum value to avoid too high volume. Select "Off
(Default Value)" or a value between "30" and "49".
Headphone Level Adjust the output level of the headphones. Select a value
between "-12 dB" and "+12 dB". (Default Value is "0 dB")
Advanced Setup | Firmware Update | Others
on the remote controller is
E
N
33