Bestway 58498 Manuel De Instrucciones página 4

Assembly (You will need a screwdriver.)
1. Carefully remove all components from the package and check to
ensure nothing is damaged. If equipment is damaged,
immediately notify the retailer from where the equipment was
purchased.
2. The sand filter should be placed on solid, level ground, preferably
a concrete slab. Position the sand filter so the Ports and Control
Valve are accessible for operation, servicing and winterizing.
3. The sand filter must be vertically fixed on ground or a certain pedestal made of wood or
concrete before use to prevent the sand filter from accidentally falling. Fully assembled
sand filter will exceed 18kg. The mounting holes should be 8mm in diameter and spaced
86 mm apart. Use two bolts and nuts with a maximum of 8mm in diameter to fasten the
sand filter to the pedestal.
Load pool-grade filter sand/Flowclear™ Polysphere.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand
0.45-0.85mm, approximately one 9kg bag should suffice. If you do not use the recommended
size of filter sand, filtering performance will be reduced and the sand filter may damaged,
thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom
Tank to submerse the Skimmer on the Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace 1 kg (2.20 lbs) sand.
C
4
Ф8mm
4
MAX.
MIN .
MAX
MIN
C
86mm
C