English
required maintenance will be warranted
for the period of time up to the first
scheduled replacement point for that
part.
Diagnosis
You, as the owner, shall not be charged
for diagnostic labor which leads to the
determination that a warranted part is
defective. However, if you claim
warranty for a component and the
machine is tested as non-defective,
STIHL Incorporated will charge you for
the cost of the emission test. Mechanical
diagnostic work will be performed at an
authorized STIHL servicing dealer.
Emission test may be performed either
at STIHL Incorporated or at any
independent test laboratory.
Warranty Work
STIHL Incorporated shall remedy
warranty defects at any authorized
STIHL servicing dealer or warranty
station. Any such work shall be free of
charge to the owner if it is determined
that a warranted part is defective.
Any manufacturer-approved or
equivalent replacement part may be
used for any warranty maintenance or
repairs on emission-related parts and
must be provided without charge to the
owner. STIHL Incorporated is liable for
damages to other engine components
caused by the failure of a warranted part
still under warranty.
The following list specifically defines the
emission-related warranted parts:
Air Filter
–
Carburetor (if applicable)
–
Fuel Pump
–
34
Choke (Cold Start Enrichment
–
System) (if applicable)
Control Linkages
–
Intake Manifold
–
Magneto or Electronic Ignition
–
System (Ignition Module or
Electronic Control Unit)
Fly Wheel
–
Spark Plug
–
Injection Valve (if applicable)
–
Injection Pump (if applicable)
–
Throttle Housing (if applicable)
–
Cylinder
–
Muffler
–
Catalytic Converter (if applicable)
–
Fuel Tank
–
Fuel Cap
–
Fuel Line
–
Fuel Line Fittings
–
Clamps
–
Fasteners
–
Where to make a Claim for Warranty
Service
Bring the product to any authorized
STIHL servicing dealer and present the
signed warranty card.
Maintenance Requirements
The maintenance instructions in this
manual are based on the application of
the recommended 2-stroke fuel-oil
mixture (see also instruction "Fuel").
Deviations from this recommendation
regarding quality and mixing ratio of fuel
and oil may require shorter maintenance
intervals.
Limitations
This Emission Control Systems
Warranty shall not cover any of the
following:
repair or replacement required
N
because of misuse, neglect or lack
of required maintenance,
repairs improperly performed or
N
replacements not conforming to
STIHL Incorporated specifications
that adversely affect performance
and/or durability, and alterations or
modifications not recommended or
approved in writing by STIHL
Incorporated,
and
replacement of parts and other
N
services and adjustments
necessary for required maintenance
at and after the first scheduled
replacement point.
FC 95, FC 110