Preparation For Use; Initial; Power Supply; Calibration - HT Italia HT9014 Manual De Instrucciones

HT9014 - HT9015

3. PREPARATION FOR USE

3.1. INITIAL

The tester has been checked from a mechanical and electrical point of view before
shipment.
Every care has been taken to make sure that the instrument reaches you in perfect
conditions.
However, it's advisable to make a rapid check in order to detect any damage which may
have occurred in transit. Should this be the case, enter immediately the usual claims with
the carrier.
Make sure that all the accessories listed in § 6.3 are contained in the package. In case of
discrepancies contact Your dealer.
In case of returning of the tester please keep to the instructions given in § 7.

3.2. POWER SUPPLY

The instrument is battery supplied. One battery 9V NEDA 1604 IEC 6F22 JIS 006P is
included in the package. Battery life: about 200 hours. When batteries are low, the symbol
" " appears on the display. Replace them immediately, following the instructions
given in § 5.2
The instrument disposes of the Auto Power OFF function (not disable) consisting in an
automatic switching off 15 minutes of idleness.

3.3. CALIBRATION

The tester complies with the technical features listed in this manual. Its performances are
guaranteed for one year.

3.4. STORAGE

In order to guarantee the accuracy of the measurements, after a period of storage under
extreme environmental condition, wait for the necessary time so that the tester returns to
normal measuring conditions (see environmental specifications, § 6.2.1).
EN - 5