Capacitance Measurement - HT Italia HT9014 Manual De Instrucciones

4.3.5. Capacitance measurement

When testing in-circuit capacitors, turn off the power of the circuit to be tested
and discharge all the capacitors
1. Rotate the switch on Ω
2. Pushing MODE key and select capacitance test. The "nF" symbol is shown at display
3. Insert the red test lead plug into VΩ
plug into COM jack (Fig. 7)
4. Connect the two long ends of test leads to the desired circuit, then reading will be
displayed. Bargraph is disabled in capacitance measurement
5. When "O.L." symbol is displayed, the result under test exceeds the maximum value that
the instrument is capable of measuring
6. For HOLD and REL features please refer to § 4.2
For readings of capacitance <40nF push PEAK/REL key before making test in
order to improve the measured result
Fig. 7: Taking Capacitance measurement
CAP position
EN - 12
CAUTION
CAPHz%Temp jack and the black test lead
CAUTION
HT9014 - HT9015