Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE. STOP CYCLE function: the washing
cycle can be stopped if you push again the cycle
pushbutton "B" (light "F" flashing now) :
to restarting washing cycl push again button "B".
Manuel self-cleaning cycle:
- Ensure that the tank is empty,
- Make sure that the machine is switched off
- Remove the overflowpipe from the tank
- Close the door of the diswasher
- Press button "A" to switch the machine on
- Self-cleaning cycle starts, you can stop it after 5
minutes,
otherwise
automatically turn off after 10 minutes. (for Machine
with drain pump the tank fills with water and stops
when maximum level is reached: empty the tank
manually and repeat the operation if needed).
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. Halos
might be caused by an insufficient rinsing: in this
case, check that the rinsing jets are clean and
there is a sufficient pressure in the water
distribution network.
In the case that residuals are present, check
that:
• the washing jets are clean
• there is detergent
• the positions of the objects in the rack are
correct.
SALT CONTROL
(for machines with Water softener)
If the glass-washer is equipped with a Water
softener the
regeneration of resins is
automatic according to parameters fixed by the
producer.
According to the water hardness, it is possibile to
modify the programming of the regeneration.
N.B. each 90 seconds of tank filling
duration, the machine stops for about
2
minutes
to
regeneration.
See the corresponding table in the installer section.
When it is necessary to add salt in the container, t
green lamp "H" lights up
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it. Clean the gasket and screw the plug.
Attention!
The lack of salt in the container damages the
machine
because
defective washing of glasses and dishes.
These damages are not covered by the warranty.
self-cleaning
cycle
carry
out
.
of
limestone,
besides
GLASSES POSITIONING
In order to obtain a successful dishwashing, it is
suitable to take care of the way dishes are
placed. It is suitable to place glasses, inside the
wire basket with the concave side towards the
bottom. Place mixed cutlery in a vertical position
into the suitable container minding not to cram
them and with hafts towards the bottom (see the
drawing).
will
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
the
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
he
3
Afterwards push button "P" for 3 seconds.
(the lamp "H" is lighted).
The discharge will stop automatically after 5
minutes. The control lamp will stop flashing.
Reinstall the flow over and shut the door.
(see also the paragraph "Daily maintenance" on
a
page 27)
26
Publicidad
