Publicidad
Idiomas disponibles
Idiomas disponibles
Setting of regeneration cycles
By default the regeneration is planned every 5 washing cycles.
However, it is possible to plan the Regeneration on the basis of water hardness.
When the number of cycles suitable for the water hardness of your system has been established, it is
possibile to configure the dip-switch on the electronic card placed in the control box.
Follow the instructions to programme the electronic board.
REGENERATION SETTING PROGRAMMING
1 - With the machine stopped, check the position of the dip-switches on the electronic board and
memorise it;
2 - Then set the dip-switch in accordance with the following table, according to the number of
washing cycles you wish to set to start the regeneration operation signaling;
ON
1 2 3 4
ON
1 2 3 4
ON
1 2 3 4
3 - Open the door of the machine;
4 - Press the START button;
5 - Keep the START button pressed and turn the machine ON by using the "A" switch;
6 - Wait for the lighting of the cycle "2" lamp;
7 - Turn the machine OFF by using the "A" switch;
8 - Reset the dip-switches according to the original position of the washing period programming;
Lavabicchieri
Lave-verres
Glasswashers
Gläserspüler
Conteggio disabilitato
ON
Compte inactif
Count -off
1 2 3 4
Nachzahlung
nicht Akt iviert
CIC LI
ON
3
CYCLES
CYCLES
1 2 3 4
ZYKLUS
CIC LI
ON
6
CYCLES
CYCLES
1 2 3 4
ZYKLUS
Lavabicchieri
Lave-verres
Glasswashers
Gläserspüler
add
ON
1 2 3 4
add
OFF
CIC LI
1
CYCLES
CYCLES
ZYKLUS
CIC LI
4
CYCLES
CYCLES
ZYKLUS
CIC LI
7
CYCLES
CYCLES
ZYKLUS
1 2 3 4
ON
OFF
(cod. 0300827)
CIC LI
ON
2
CYCLES
CYCLES
1 2 3 4
ZYKLUS
CIC LI
ON
5
CYCLES
CYCLES
1 2 3 4
ZYKLUS
Publicidad
