Metabo HPT C 7UR Manual De Instrucciones página 17

(1) Turn the base face up (Fig. 20) and loosen the lever (A).
(2) Apply a square to the base and the saw blade and, turning the
Hex. socket screw with a Hex. bar wrench, shift the position of
the base to produce the desired right angle.
7. Inspecting and maintaining the lower guard
Always make sure that the lower guard moves smoothly.
In the event of any malfunction, immediately repair the lower
guard.
For cleaning and maintenance, use an air gun or other tool
to blow clean the space between the lower guard and gear
cover as well as the rotation part of the lower guard with dry air
(Fig. 21).
Doing so is eff ective for the emission of chips or other particles.
Accumulation of chips or other particles around the lower guard
may result in malfunction or damage.
WARNING:
To prevent dust inhalation or eye irritation, wear protective safety goggles and a dust mask when using
an air gun or other tool to clean the lower guard, ventilation holes or other parts of the product.
8. Service parts list
CAUTION:
Repair, modifi cation and inspection of metabo HPT Power Tools must be carried out by a metabo HPT
Authorized Service Center.
This Parts List will be helpful if presented with the tool to the metabo HPT Authorized Service Center
when requesting repair or other maintenance. In the operation and maintenance of power tools, the safety
regulations and standards prescribed in each country must be observed.
MODIFICATIONS:
metabo HPT Power Tools are constantly being improved and modifi ed to incorporate the latest technological advancements.
Accordingly, some parts may be changed without prior notice.
Base
Fig. 20
Ensure smooth
movement of lower guard
Space between
lower guard
and gear cover
Housing vent
Fig. 21
English
Square
Hex. Socket Screw
Rotation part of
the lower guard
Air gun
17