Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6. Selecting the appropriate drill bit
When boring concrete or stone
Use the drill bits specified in the Optional Accessories.
When boring metal or plastic
Use an ordinary metalworking drill bit.
When boring wood
Use an ordinary woodworking drill bit.
However, when drilling 1/4" (6.5 mm) or smaller holes, use a metalworking drill bit.
7. Mounting and dismounting of the bit (Fig. 2)
(1) Open the chuck jaws, and insert the bit
into the chuck.
(2) Place the chuck wrench in each of the
three holes in the chuck, and turn it in
the clockwise direction (viewed from the
front side). Tighten securely.
(3) To remove the bit, place the chuck
wrench into one of the holes in the chuck
and turn it in the counterclockwise
direction.
8. Fixing the side handle (Fig. 3)
Attach the side handle to the mounting part.
Rotate the side handle grip in a clockwise direction to secure it.
Set the side handle to a position that is suited to the operation and then securely tighten
the side handle grip.
To attach a depth gauge on the side handle, insert the gauge into the U-shaped groove
on the side handle, adjust the position of the depth gauge in accordance with the desired
depth of the hole, and firmly tighten the side handle grip. (Fig. 4)
Side handle
Loosen
Tighten
Fig. 3
Drill
Chuck
chuck
wrench
Tighten
Loosen
Fig. 2
Depth gauge
Side handle
Loosen
Fig. 4
English
Tighten
11
Publicidad
Tabla de contenido
