In-Band Connections (Web Browser/ Telnet); Default Gateway; Starting A Telnet Session - Longshine LCS-SW2402S Manual Del Usuario

5.2 In-Band Connections (Web Browser / Telnet)
To manage the switch through in-band access, you should configure the
management station with an IP address and subnet mask compatible with
your clustering switch.
Factory Default value:
IP
Subnet Mask

Default Gateway

Both standalone switch and the cluster can be managed using either a
standard Web Browser or a Telnet session from any computer attached to
the network. The SNMP management feature also permits the switch to be
managed from any SNMP network management station running a
network management program.
To manage the Standalone switch
Access the switch with its IP address "10.0.0.1" (factory default value)
To manage any of the Clustering switch
Access the switch with the IP address of Master device in the
management stack. Then select the switch you want to manage in the
first page

Starting a Telnet Session

To access the switch through a Telnet session
1. Sure of the switch is configured with an IP address and the switch is
reachable from a PC
2. Start the Telnet program on a PC and connect to the switch
Note
The management functions of Telnet program are exactly the same with
web-based management interface but in text mode. For further operation, please
refer to 'Starting a Web Browser Session'.
10.0.0.1
255.0.0.0
10.0.0.254
E-24