Extension Cords - Genesis GHD1260 Manual Del Operario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Keep cutting tools sharp and clean.
cutting edges are less likely to bind and are easier to control
• Feed the work piece in the correct direction and speed.
piece into a blade, cutter, or abrasive surface against the direction of the cutting tool's direction
of rotation only. Incorrectly feeding the work piece in the same direction may cause the work
piece to be thrown out at high speed.
• Never leave the tool running unattended, turn the power off.
leave the tool until it comes to a complete stop.
• Never start the power tool when any rotating component is in
contact with the work piece.
WARnIng:
OR OTHER AIRBORnE PARTICLES, InCLUDIng WOOD DUST, CRYSTALLInE
SILICA DUST AnD ASBESTOS. Direct particles away from face and body.
Always operate tool in a well-ventilated area and provide for proper dust
removal. Use dust collection system wherever possible. Exposure to the dust
may cause serious and permanent respiratory or other injury, including silicosis
(a serious lung disease), cancer, and death. Avoid breathing the dust, and avoid
prolonged contact with the dust. Allowing dust to get into your mouth or eyes,
or lay on your skin may promote absorption of harmful material. Always use
properly fitting nIOSH/OSHA approved respiratory protection appropriate for
dust exposure, and wash exposed areas with soap and water.
SERVICE
Have your power tool Serviced by a qualified repair person using
only identical replacement parts.
is maintained.
• Service your power tool periodically.
disassemble any portion of the tool since internal wires may be misplaced or pinched.
WARnIng:
AnD OPERATIng InSTRUCTIOnS BEFORE USIng THIS EQUIPMEnT. Failure
to follow all instructions listed below may result in electric shock, fire and/or
serious personal injury.

EXTEnSIOn CORDS

grounded tools require a three wire extension cord
use either a two or three wire extension cord. As the distance from the power supply outlet increases,
you must use a heavier gauge extension cord. using extension cords with inadequately sized wire
causes a serious drop in voltage, resulting in loss of power and possible tool damage. Refer to the
table shown below to determine the required minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a
14-gauge cord can carry a higher current than a 16-gauge cord. When using more than one extension
cord to make up the total length, be sure each cord contains at least the minimum wire size required.
If you are using one extension cord for more than one tool, add the nameplate amperes and use the
sum to determine the required minimum wire size.
USE OF THIS TOOL CAn gEnERATE AnD DISBURSE DUST
READ AnD UnDERSTAnD ALL WARnIngS, CAUTIOnS
SAVE THESE INSTRUCTIONS
Properly maintained cutting tools with sharp
.
This will ensure that the safety of the power tool
When cleaning a tool, be careful not to
. Double insulated tools can
feed the work
Do not
5

Publicidad

Tabla de contenido
loading

Tabla de contenido