HP OneLam Combo A3 Manual De Instrucciones página 23

Using the Cutting Device
1
Guide the paper/pouch between the stops and under the cutting device rail to the required
cutting position (C).
Use the positioning aids on the top of the laminator to align the material to be cut as required.
2
Press the cutting head down firmly, in order to produce a good cut and slide the cutting head
along the rail over the paper/pouch (D). Fix the material in place with your hand so that it does
not shift while being cut.
Î The paper/pouch has been cut as required.
Changing the Cutting Head
You can change the cutting head on the cutting device as necessary.
To obtain a new cutting head, please contact your supplier or the manufacturer.
1
Release the plastic rail (F) from its fixation.
2
Guide a suitable tool (e.g. the plastic rail or slot screwdriver) in the recess (G) beside the right-
hand holder, press the tool down and maintain the pressure.
Î The lock in the right-hand holder is released.
F
C
G
- 23 -
D
H
EN
I