Positioning And Starting Up The Laminator; Before You Start - HP OneLam Combo A3 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 95

Positioning and Starting Up the Laminator

The following section should help when starting up the laminator.
1
Set the laminator down on a level, stable working surface close to an easily accessible power
socket.
2
Switch the power switch to OFF.
Only use the power cable supplied.
3
Connect the power cable to the connection socket in the laminator.
4
Connect the power plug to a power socket.
5
Switch the power switch to ON.
Î The transport rollers start to rotate.
Î The "COLD" status LED lights up GREEN
Î The laminator has been put into operation.

Before You Start

Please observe the following information to ensure continued reliable operation of the laminator.
Information on the Material
Do not laminate metallic, wet or uneven materials.
The material to be laminated, including the laminating pouch, must not be thicker than 0.5 mm.
Thin and soft materials should be laminated in laminating pouches with the largest foil thickness
(125 µ).
If possible, do not use too many small pieces of material in one laminating pouch.
Information on the Laminating Pouches
Only use foil pouches intended for lamination purposes.
Other types of foil, such as transparent film, are not suitable for laminating.
Only use hot laminating pouches for "Hot laminating" operating mode.
Only use cold laminating pouches for "Cold laminating" operating mode.
Choose the size of laminating pouch according to the material to be laminated.
If laminating pouches need to be cut, only cut the laminating pouches after laminating.
- 19 -
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

3162

Tabla de contenido