Using The Cutting Device And Corner Rounder - HP OneLam Combo A3 Manual De Instrucciones

EN

Using the Cutting Device and Corner Rounder

When required, you can cut the paper to be laminated or the laminating pouch to size using the
cutting device and cut the corners of the pouch with the corner rounder.
Please note that you must not insert more than three sheets of paper (80 g/m²) and not more
than one laminated document in the cutting device or corner rounder at a time.
Setting the Cutting Pattern on the Cutting Device
The cutting device is on the top side of the laminator.
The cutting device provides the following cutting patterns which can be chosen using the selector
switch on the cutting head of the cutting device.
■
straight cut,
■
wave cut,
■
perforation.
The cutting pattern set is indicated by the corresponding symbol at the top of the selector
switch.
The knife blades in the cutting head are surrounded by a protective housing.
1
Pull out the selector switch (A, B) and turn it to the required cutting pattern.
Î The selector switch latches audibly into place.
Î The cutting pattern selected is set-up.
A
- 22 -
B