Instructions To Convert To A Different Type Of Gas; Replacing Injectors - Whirlpool GOA 6423NB Manual De Instrucciones

4. Instructions to convert to a different type of gas

Important:
• The adaptation for use another type of
gas, pressure or other power
corresponding adjustment, must be
performed by a qualified professional gas
company or manufacturer's
representative.
• This cooktop is set for use with Natural
Gas, supply pressure of 20 mbar.
Use pressure regulators adequate to the
gas pressures indicated in the installation
instructions.
- If gas conversion injectors are not
included, get in touch with the After-
Sales Service and ask for them.

4.1 Replacing injectors

Important:
This operation shall be made by a
qualified professional, by the gas supplier
or by a manufacturer's representative.
(See injectors table under "Technical
characteristics").
• Remove grids (A).
• Remove burners (B).
• Using a socket spanner of appropriate size
(C), unscrew the injector to be replaced.
• Replace it with an injector suitable for the
new type of gas.
• Reassemble the injector in (D).
• If you have a multiple crown burner, use
side spanner to replace the injector (E).
Manual W10777748.indd 33 Manual W10777748.indd 33
- Adjust minimum supply.
Note:
If liquefied petroleum gas is used
(G30/G31), the minimum gas setting screw
must be tightened as far as it will go.
Important:
• Any broken or destroyed security seal
must be replaced prior verification of
the correct installation and operation of
the devices.
• Should you experience difficulty in
turning the burner knobs, please get in
touch with the After-Sales Service
for replacement.
Before installing the cooktop, affix the gas
calibration plate supplied with the injectors
so that it covers the existing information
relating to gas calibration.
B
C
E
D
33
A
F
02/09/15 09:23 02/09/15 09:23