Makita DTW700 Manual De Instrucciones página 9

The type of the application mode changes every time you press the button
You can change the application mode within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the application mode approximately one minute if you press the but-
ton or .
Application mode
(Assist type displayed on panel)
Bolt mode
Bolt mode (1)
Bolt mode (2)
.
Feature
Clockwise
This mode helps to repeat
screwdriving continuously
with equal torque. This mode
also helps to reduce the risk of
breakage of bolts/nuts due to
overtightening.
Counterclockwise
This mode helps to prevent a
bolt from falling off. When loos-
ening a bolt with the tool driving
in counterclockwise rotation,
the tool automatically stops or
slows down after the bolt/nut
gets enough loosened.
NOTE:
The timing to stop the driving
varies depending on the type
of the bolt/nut and material to
be driven. Make a test driving
before using this mode.
Clockwise
The tool stops automatically as
soon as it has started impact
blows.
Counterclockwise
The impact force is 4. The tool
stops automatically as soon as
it has stopped impact blows.
Clockwise
The tool stops automatically
approximately 0.5 second later
from the moment that the tool
has started impact blows.
Counterclockwise
The impact force is 4. The tool
stops automatically approxi-
mately 0.2 second later from
the moment that the tool has
stopped impact blows.
9 ENGLISH
Purpose
Clockwise
Preventing over tightening of
bolts.
Counterclockwise
Loosening bolts.
–
–