Cause And Action - CASO DESIGN VC9 Manual De Instrucciones

18.2

Cause and Action

The table below helps to locate and resolve minor faults.
Error
Vacuum unit is not
functioning
The first weld on the
cut off piece of the roll
is not being carried
out.
A complete vacuum is
not being created in
the bag.
The bag is not being
welded correctly
The bag does not hold
the vacuum after it has
been welded shut
The bag melts.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
caso Vakuumierer VC9
Possible cause
Power plug is not plugged in
Defective power cable or plug Send device to Customer Service
Defective electrical socket
Roll is not positioned
correctly
The open end of the bag is
not completely inside the
vacuum chamber
The bag is defective
There is dirt on the welding
and the normal seals
The welding bar is
overheating so that the bag
melts
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
The sealing bar overheats
and melts the bag.
Please note
Rectification
Plug in mains plug!
Select another electrical socket
Follow the steps in the chapter
"Vacuum packaging in a bag
originating on the roll"
Position the bag correctly
Select another bag
Clean the seals and retry
correctly once they are dry
Open the cover on the unit and
let it cool down for a few minutes
Select another bag; wrap paper
serviettes around any sharp
edges on the content
Open the bag again and clean
the upper internal part of the bag
and remove any foreign matter
that might be on the welding bar
before you weld the bag shut
again.
Open the lid of the device and
allow the sealing bar to cool down
a few minutes.
42