Connections; Connecting The Speakers And Antenna - Yamaha MCR-B020 Manual De Instrucciones

Connecting the speakers and antenna

Connect the speakers and antenna.
Do not connect this unit's power cable until you've finished connecting all cables.
If the radio reception is poor, try changing the height or direction or placement of the antenna to find a location that has better
reception.
If you use a commercially available outdoor antenna instead of the supplied antenna, reception may be better.
Speakers
• You must peel off the insulation (covering) from the tip of the speaker cable to expose the conductor.
• Check the connections; make sure that left and right (L, R) and polarity (red: +, black: –) are connected correctly. If connections are
incorrect, the sound will be unnatural and the low frequencies may be insufficient. There might not be any sound at all if connections are
incorrect.
• Take care that the conductors of the speaker cable do not touch each other, and that the conductors do not touch any other metal part.
Such conditions can damage this unit or the speakers.
• Use only the supplied speakers. Using other speakers may result in unnatural sound.
• If you're using this unit nearby a CRT display and you notice distorted color or noise in the display, move the speakers farther away from
the display.
Connect the FM
antenna plug to the
rear panel FM
antenna terminal
with the side
illustrated on the left.
AM antenna
(North America
model only)
Signal reception may be
inadvertently affected if a digital
device is located near the antenna.
Assembling AM antenna
4
En

CONNECTIONS

FM antenna
Fix the end of the FM antenna
to a wall.
Reset button
(☞ P. 18)
The AM antenna cable is not polarized.
When you've finished making
connections, pull gently on the cable to
ensure that the connection is solid.
Twist the bare wires
tightly so the individual
strands are not splayed.