Humid Areas - DeWalt DXCMH1608WB Manual De Instrucciones

Place air compressor at least 4 feet (1.2 m) away from obstacles
that may prevent proper ventilation. Keep unit away from areas
that have dirt, vapor and volatile fumes in the atmosphere which
may clog and gum up the intake filter and valves, causing inefficient
operation.

HuMID AreAs

In frequently humid areas, moisture may form in the pump and
produce sludge in the oil, causing running parts to wear out
prematurely. Excessive moisture is especially likely to occur if
the unit is located in an unheated area that is subject to large
temperature changes. Two signs of excessive humidity are external
condensation on the pump when it cools down and a "milky"
appearance in compressor oil. You may be able to prevent moisture
from forming in the pump by increasing ventilation or operating for
longer intervals.
noIse ConsIDerAtIons
Consult local officials for information regarding acceptable noise
levels in your area. To reduce excessive noise, use vibration mounts
or silencers, relocate the unit or baffle walls. Contact a D
service center or call 1-888-895-4549 for assistance.
trAnsPortInG
WARNING: Risk injury from lifting. Unit weighs more than 171 lbs.
(77.6 kg) Do not move or lift without assistance.
NOTICE: Risk of property damage. The wheels and handle do
not provide adequate clearance,
stability or support for pulling
the unit up and down stairs or
steps. The unit must be lifted, or
pushed up a ramp.
NOTICE:
Risk of property
e WALT
Q, R
Q, R
S
Q
damage. Place engine fuel valve lever (O) in the OFF position
before moving or transporting unit.
When transporting the compressor in a vehicle, trailer, etc. ensure
that the air tank is drained and the unit is secured and placed on
a protective mat on a flat horizontal surface. Do not store in a
standing position.
note: Use recommended tie down points (Q) when transporting.
Use care when driving so to avoid tipping the unit over in the vehicle.
Damage can occur to the unit or surrounding items if unit is tipped.
Use a ramp if loading or unloading the unit from a height of more
than 12" (30.5 cm).
lIftInG
Always lift from the recommended lift points (R).
WARNING: Risk injury from lifting. Unit weighs more than 171 lbs.
(77.6 kg) Do not move or lift without assistance.
NOTICE: Risk of property damage. Place engine fuel valve lever (O)
in the OFF position before moving or transporting unit.
MoVInG
1. Grasp handle (S) of compressor, and lift compressor high
enough so unit can be rolled on the front tire(s).
WARNING: Risk of unsafe operation. Ensure proper footing and
use caution when rolling compressor so that unit does not tip or
cause loss of balance.
NOTICE: Risk of property damage. Place engine fuel valve lever (O)
in the OFF position before moving or transporting unit.
2. When location is reached slowly lower rear of compressor to
ground. Always store compressor in a horizontal position. Do
not store in a standing position.
note: Should the unit tip over, hard starting and smoking will occur
due to oil spillage.
12