Auxiliary Handle - Bosch HDH181X Instrucciones De Funcionamiento Y Seguridad

BM 2610032842 04-14_DDH181X HDH181X 4/9/14 7:10 AM Page 9
Disconnect battery pack
W RNING
from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
INSERTING BITS
Move reverse switch lever to the center "OFF"
position. Remove battery pack and rotate the
clutch ring to
" ". Rotate the chuck sleeve counter-
clockwise viewing from chuck end, and open
chuck to approximate drill bit diameter. Insert
a clean bit up to the drill bit flutes for small bits,
or as far as it will go for large bits. Close chuck
by rotating the chuck sleeve clockwise and
securely tighten by hand (Fig. 2).

AUxILIARy HANDLE

The tool must be supported with the auxiliary
handle, which can be swiveled 320˚. To
reposition and/or swivel the handle, loosen the
FIG. 3
1
1
DEPTH GAUGE
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
FIG. 5
1
2
Assembly
the drill bit symbol
3
2
Do not use the power of
W RNING
the drill while grasping
chuck to loosen or tighten bit. Friction burn
or hand injury is possible if attempting to grasp
the spinning chuck.
FIG. 2
CHUCK SLEEVE
DRILL BIT
hand grip, move the handle to the desired
position along the barrel and securely retighten
the hand grip (Fig. 3 & 4).
FIG. 4
Setting depth: After the auxiliary handle is
installed, slide the depth gauge to desired
depth and securely tighten wing knob (Fig. 5
& 6).
FIG. 6
X
-9-
BIT HOLDER
SCREWDRIVER BIT
3
2
1
3