Echo 99944200665 Instrucciones Para La Instalación página 2

2
-
INSTALL U HANDLE AND HARNESS RING
Tools Required: Screwdriver, 4 mm Hex Wrench, 19 mm Wrench.
Parts Required: U-Handle Assembly, Harness Clamp, Lower Handle
Bracket, Lower Handle Bracket Clamp, 8 mm Square
Nut, 8 mm x 55 mm Long Hex Head Bolt, 8 mm Flat
Washer, 5 mm x 30 mm hex socket bolts (3), Plastic
Cable Clamps (2).
1. Close choke and remove air filter cover.
2. Disconnect two (2) ignition stop leads (A, B).
3. Remove inner throttle linkage cable from carburetor swivel (C).
4. Loosen cable retainer plate screw (D) and pivot retainer plate
down.
5. Remove throttle cable from retainer block (E).
6. Loosen bolt (F) and pull drive shaft assembly from clutch case.
7. Loosen two (2) brass rear handle clamp screws (G) and pull rear
handle (H) from the drive shaft assembly.
8. Loosen two (2) screws (I) and remove front handle.
9. Insert square nut (J) in lower handle bracket (K) and place bracket
on drive shaft 400mm (15 3/4 in.) from engine end of drive shaft.
10. Secure with lower handle bracket clamp (L) and three (3) 5mm x
30mm hex socket screws.
11. Position harness ring (M) 220mm (8-5/8 in.) from engine end of
drive shaft assembly. DO NOT tighten at this time.
I I
NSTALLATION NSTRUCTIONS
U-H K
ANDLE IT
C
D
E
F
H
I
J
K
L
400 mm
(15-3/4 in.)
220 mm
K
L
(8-5/8 in.)
A
B
F
G
M
ENGINE
END