Descargar Imprimir esta página

Starting Instructions - Echo 99944200665 Instrucciones Para La Instalación

Publicidad

Idiomas disponibles

Idiomas disponibles

4
BALANCE AND ADJUST UNIT
1. Put on harness and attach unit to harness.
2. Slide harness clamp (M) up and down until unit balances with
head approximately 50 - 75 mm (2 - 3 in.) from the ground.
3. Tighten clamp screw.
4. Loosen upper U-Handle clamp screws (Q), and position U-Handle
for comfortable operation.
5. Tighten U-Handle clamp screws and 8 mm clamp bolt securely.
NOTE
In case of Emergency, the trimmer/brushcutter can be released from
the harness by pulling up on the quick-release collar.
IMPORTANT
If non-standard monofilament heads, METAL/PLASTIC blades or
cultivators etc., are used, THE CARBURETOR MUST BE RESET or
serious engine damage can occur. See "Carburetor Adjustment" in
the unit Operator's Manual.

STARTING INSTRUCTIONS

Installation of the U-handle kits on units requiring wide-open throttle
start (starting with throttle trigger fully depressed) requires the
following changes to starting procedures:
1. Lightly place knee on drive shaft to stabilize unit during starting.
Do not apply excessive downward force, or damage to unit can
occur.
2. Firmly grasp right hand grip and throttle trigger lockout with left
hand, and fully depress throttle trigger to wide open position.
3. Pull recoil starter handle, and start unit as instructed in Operator's
Manual.
ECHO CONSUMER PRODUCT SUPPORT: If you require assistance or have questions concerning the application,
operation or maintenance of this product you may call the ECHO Consumer Product Support Department at 1-800-673-
1558 from 8:30 am to 4:30 pm (Central Standard Time) Monday through Friday. Before calling, please know the model and
serial number of your unit to help your Consumer Product Support Representative.
REPLACEMENT MANUALS: Operator's, Parts, and Safety Manuals may be obtained from ECHO, or may be
downloaded free from ECHO's website. Make sure you know the model number and serial number of your unit so you
can obtain the correct manual.
I
I
NSTALLATION
NSTRUCTIONS
U-H
K
ANDLE
IT
2 - 3 in.
Q
N
M
M

Publicidad

loading