Echo 99944200665 Instrucciones Para La Instalación página 3

I
NSTALLATION
12. Install U-Handle assembly on lower bracket, and secure with one
(1) 8mm x 55mm bolt and one (1) 8 mm flat washer (N). Do not
tighten bolt securely until final adjustments are completed.
13. Install power head, and align gear box, power head and U-handles.
Tighten bolt (F).
14. Place inner cable in large hole of carburetor swivel (C)
15. Hold carburetor swivel in position, and place throttle cable cap
nd
flange in 2 slot from top of retainer block (E).
16. Check throttle for freedom of movement, and that wide open
throttle/low idle extremes are adjusted properly. Move throttle
cable cap in retainer block to make necessary adjustments.
17. Pivot retainer plate up to secure throttle cable cap, and tighten
screw (D).
18. Connect ignition stop leads (A) and (B).
19. Bundle and secure ignition leads against engine housing with clip
(O).
20. Place outer throttle cable tubing in clip (P).
21. Install air filter and cover, and tighten knob securely.
22. Secure throttle cable tubing to drive shaft with two (2) plastic cable
clamps provided.
Install Hip Pad (Optional)
23. Attach hip pad to harness as shown.
I U-H
NSTRUCTIONS
K
ANDLE IT
N
C
D
E
F
B
P
3
A
O