Before You Begin - Campbell Hausfeld CE4101 Manual De Instrucciones Y Lista De Piezas

BEFORE YOU BEGIN

Introduction
Air compressor units are intended to provide compressed air to power pneumatic tools, operate spray guns and
supply air for pneumatic valves and actuators. The pumps supplied with these units have oil lubricated bearings.
A small amount of oil carryover is present in the compressed air stream. Applications requiring air free of oil vapor
should have the appropriate filters installed. The air compressor units are to be mounted per the instructions
provided on a solid floor. Any other use of these units will void the warranty and the manufacturer will not be
responsible for problems or damages resulting from such misuse.
QUICK REFERENCE
Recommended Oil (2 Options)
Single viscosity SAE 30 ISO100 nondetergent compressor oil. Part number
ST126700AV.
10W30 synthetic oil such as Mobil 1
Oil Capacity
Approximately 40 oz.
UNPACKING
tubes or coolers. Do not use unit to lift other attached equipment.
After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for
loose, missing or damaged parts. Check to be sure all supplied accessories are enclosed with the unit. In case of
questions, damaged or missing parts, please visit www.campbellhausfeld.com for customer assistance.
Required Items - Not Included
• Oil
.
®
Do not lift or move unit without appropriately rated equipment. Be sure
the unit is securely attached to lifting device used. Do not lift unit by holding onto
Do not operate unit if damaged during shipping, handling or use. Damage
may result in bursting and cause injury or property damage.
1