Before You Begin - Campbell Hausfeld CE9002 Instrucciones De Funcionamiento Y Manual De Piezas

BEFORE YOU BEGIN

Introduction
The Campbell Hausfeld two-stage air compressors are oil lubricated reciprocating compressors.
Basic Series Models Include:
• Compressor pump
• ASME air receiver with safety valve
• Electric motor
• Starter
• Pressure switch
Fully Packaged Series Models Include:
• Compressor pump
• ASME air receiver with safety valve
• Electric motor
• Starter
• Pressure switch
• Air cooled aftercooler
• Automatic tank drain
• Vibration isolation pads
• Shut-off valve
Quick Reference
Recommended Oil (2 Options)
Single viscosity SAE 30 ISO100 nondetergent compressor oil. Part number
ST125303AV (0.5 qt) or ST126701AV (4 qt).
10W30 synthetic oil such as Mobil 1
Oil Capacity
Approximately 6 quarts
UNPACKING
tubes or coolers. Do not use unit to lift other attached equipment.
After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for
loose, missing or damaged parts. Check to be sure all supplied accessories are enclosed with the unit. In case of
questions, damaged or missing parts, please visit www.campbellhausfeld.com for customer assistance.
Required Items - Not Included
• Oil
or CE0032 (1 qt).
®
Do not lift or move unit without appropriately rated equipment. Be sure
the unit is securely attached to lifting device used. Do not lift unit by holding onto
Do not operate unit if damaged during shipping, handling or use. Damage
may result in bursting and cause injury or property damage.
1