What's In The Box; Power; Precautions For Use; Maintenance - THOMSON TT600BT Modo De Empleo

What's in the box

Check and identify the contents of your package:
• Main unit
• Aluminum platter
• Platter mat
• 45 RPM adapter
• Dust cover for the main unit
• RCA cable
• PC encoding cable
• AC adapter
• User manual

Power

CAUTION
• Risk of product damager! Make sure that the power voltage
corresponds to the voltage printed on the back label.
• Risk of electric shock! When you unplug the AC power cord
always pull the plug from the socket. Never pull the cord.
• Before connecting the AC power cord, ensure you have completed
all other connections.
Place the unit in the desired position and unravel the mains cable. Insert the cable into the supply
socket and switch on if applicable.

Precautions for use

• Do not place anything on the turntable cover. Objects on the cover might cause noise due to
vibrations or fall off, especially during playback.
• Avoid placing the unit in direct sunlight, close to a source of heat or in other similar conditions. Do
not place the unit on top of an amplifier or other equipment that might generate heat that exceeds
the operating temperature range of this unit. Doing so could cause discoloration, deformation or
malfunction.
• As the unit could become warm during operation, always leave sufficient space around it for
ventilation. When installing this unit, leave a little space between it and other devices and walls to
allow good heat dissipation.
• When placing it in a rack, for example, leave at least 35 cm open above it and 10 cm open behind it.
Failure to provide these gaps could cause heat to build up inside and result in fire.
• Do not move the unit during playback. During playback, the record rotates. Do not lift or move the
unit during playback. Doing so may damage the record, the stylus, the cartridge or the unit.
• Always remove the record before relocating or moving this unit. Moving the unit with a record on
the turntable could damage the record, the stylus and the cartridge or could cause a malfunction.
• The voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in
any doubt regarding this matter, consult an electrician.

Maintenance

• If the surface of the unit gets dirty, wipe it with a soft cloth or use diluted mild liquid soap. Allow the
surface of the unit to dry completely before using.
• Do not use chemical cleaning cloths, thinner or similar substances as they could damage the surface
or the unit.
Caution
For safety, disconnect the power cord from the socket before cleaning.
- EN 3 -