Victron energy Blue Smart IP65 Charger Serie Manual página 17

iii.
Open the 'Product info' page by selecting 'Product info'.
iv. Beside 'Bluetooth Enabled' select 'DISABLE' to open the 'Disable Bluetooth' window.
v. Select 'OK' as confirmation.
d) Re-enabling Bluetooth
It is possible to re-enable Bluetooth using the MODE button.
To re-enable Bluetooth:
i. Depress and hold the MODE button (on the Blue Smart Charger) for 10 seconds.
ii.
After 10 seconds have elapsed all blue LEDs will blink twice to indicate that
Bluetooth has been re-enabled, and all Bluetooth settings reset.
During this procedure:
i. Bluetooth is re-enabled
ii.
The PIN code is rest to default (000000)
iii. Any active Bluetooth connections are disconnected
iv.
All Bluetooth pairing information is cleared
15