Kenmore 125.10341 Manual De Uso Y Cuidado página 10

3. To change power setting, touch the
speed indicator icon for desired power
setting (Low or High).
Low Speed
NOTE: This vacuum cleaner is equipped
with a memory function that allows the
vacuum to start in the last power setting.
CLEANING WITH THE HAND VACUUM
1. To remove the
hand vacuum, press
the release button
and detach the hand
vacuum from the
main body.
2. To turn on the hand vacuum, press the
power switch located on top of the handle.
NOTE: When battery power is low, the
battery charge indicator around the switch
will flash.
To charge, place the hand vacuum into the
main body and place the whole unit onto
the charger base.
4. After vacuuming, turn the unit off by
touching the power icon for 2 seconds.
NOTE: Holding for less than 2 seconds
causes no action.
High Speed
NOTE: When the vacuum is low on battery
power, the control panel or the battery icon
will flash. The flashing will continue until
the unit is placed on the charging station
or is completely out of battery power.
3. To clean difficult to reach areas, use
the combination tool by inserting end of
combination tool into the hand vacuum as
shown.
- 10 -
Power Button