Cleaning And Maintenance - Bestron ABG450BSE Manual Del Usuario

8. P ress the foot button on the nozzle to set the
combi nozzle for use on hard or soft surfaces,
see Figure 3c. For use on hard surfaces, press
the foot button on the combi nozzle to extend the
brushes. Lift the button for use on soft surfaces.
AcceSSory
This vacuum cleaner is supplied with a crevice tool
with a narrow nozzle, which you can use to clean
radiators, window frames, crevices, small openings,
and similar (see Figure 4).
oPerAtion - Storage after use
1. Remove the plug from the wall socket.
2. P ress the rewind button and keep it pressed in; the
power cord will automatically rewind onto the reel.
G uide the power cord whilst it rewinds onto the
reel, since otherwise the cord could become
tangled or the plug could strike the back of the
appliance. Take hold of the power cord near the
mark, and allow it to gently slide through your
fingers back into the appliance, see Figure 5.
3. S tand the vacuum cleaner upright. An
attachment slot for the accessory bracket is
fitted to the back of the vacuum cleaner next to
the front castor (see Figure 6). Slide the bottom
of the accessory bracketinto the slot. This avoids
the need to dismantle the vacuum cleaner after
use; you can store the assembled appliance and
retrieve it again quickly when you need it.

cleAninG And mAintenAnce

1. Clean the outer surface of all parts with a damp cloth and a cleaner suitable for plastics. Make sure no
moisture gets into the appliance.
2. Over the course of time dust and dirt can accumulate around the wheel axles, thereby preventing the
wheels from turning easily. Consequently they should be kept clean.
• Never immerse the appliance, plug or power cord in water.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
cleAninG And mAintenAnce - changing the dust bag
1. C hange the dust bag immediately once the 'dust bag full' indicator turns red, see Figure 7 on page 25.
I t is possible that the indicator turns red whilst the dust bag is not yet full. If so, then the nozzle, hose or
tubes may be blocked. These will then need to be cleaned.
2. O pen the cover by pulling the cover release (dust bag) upwards. Remove the dust bag from the holder,
and dispose of it in a dustbin.
3. F it a new dust bag in the holder and press into position.
4. Close the cover, and press until it clicks into place.
user's instructions
a b
c
24