Bestron DC30T Manual Del Usuario página 43

5. Lead the wires emerging from your ceiling through the opening in the mounting plate (E).
6. Screw the mounting plate to the ceiling (F). Make sure the mounting plate is mounted firmly enough to
hold a minimum weight of 23 kg (51 lb).
7. Now connect the wires to the terminal block on the mounting plate in the following way (G):
• Blue wire → N
• Brown or black wire → L
• Earth wire (yellow-green) →
MONTAGE - Installing the down rod onto the motor (option 1)
H
1. Remove the cotter pin and metal pin from the down rod (see figure H).
2. Lead the down rod through the canopy (I).
3. Untighten the two screws on the motor (J).
4. Remove the cable binder from around the wiring and lead the wires through the down rod (K). Make sure
not to damage the wiring in the process.
L
5. Reinstall the metal pin into the down rod (L) en secure it by reinsterting the cottor pin (M).
6. Tighten the two screws on the motor (N).
The down rod has now been installed correctly.
MONTAGE - Installing the canopy directly onto the motor (option 2)
This ceiling fan type offers the possibility of installing the canopy directly onto the motor housing, without
using the down rod. This can be useful, for example, when installing the fan in low ceiling areas. Please note
that choosing this option may affect the air circulation.
I J
M
43
EN
K
N