Assembly - Remington RM2BL Manual Del Operador

WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before removing or
installing blower tubes or nozzles.
INSTALLING THE BLOWER TUBE AND NOZZLE
Installing the Blower Tube
1. Align the bumps on the upper end of the blower tube with the
slots on the blower outlet (Fig. 1).
2. Insert the blower tube into the blower outlet (Fig. 1).
3. While holding the handle, twist the blower tube clockwise until it
locks into place (Fig. 1).
Installing the Nozzle
1. Align the slots on the nozzle with the bumps on the lower end of
the blower tube (Fig. 2).
2. Install the nozzle onto the blower tube (Fig. 2).
3. While holding the blower tube, twist the nozzle clockwise until it
locks into place (Fig. 2). The tabs on the blower tube should
align with the tabs on the nozzle (Fig. 3).
REMOVING THE BLOWER TUBE AND NOZZLE
Removing the Blower Tube
1. Insert a flat-head screwdriver into the tube lock. Turn the
screwdriver counterclockwise 1/4 turn and hold it in place (Fig. 4).
2. Twist the blower tube counterclockwise until it unlocks from the
blower outlet (Fig. 4).
3. Remove the blower tube from the blower outlet.
Removing the Nozzle
1. While holding the blower tube, twist the nozzle counterclockwise
until it unlocks from the blower tube.
2. Remove the nozzle from the blower tube.

ASSEMBLY

Bumps
Slot
Tabs
Tube Lock
7
Slots
Blower
Outlet
Blower Tube
Fig. 1
Bump
Blower Tube
Nozzle
Fig. 2
Fig. 3
Fig. 4
Handle
Tabs