Assembly - Remington RM300-BL Manual Del Operador

WARNING:
To prevent serious personal injury, take the
following steps before installing or removing the nozzle:
• Stop the unit and allow the impeller to come to a
complete stop
• Remove the battery.
WARNING:
To prevent serious personal injury, do not
insert hands into the nozzle or blower tube when removing
or installing the nozzle.
INSTALLING AND REMOVING THE NOZZLE
Installing the Nozzle
1. Align the bump slots on the inside of the nozzle with the bumps
on the blower tube (Fig. 1). Push the nozzle onto the blower tube.
2. Turn the nozzle clockwise until it locks into place with an audible
click (Fig. 2).
Removing the Nozzle
1. Turn the nozzle counterclockwise until it unlocks from the blower
tube (Fig. 2).
2. Pull the nozzle off of the blower tube (Fig. 2).
WARNING:
Only use this attachment with RM300-PH
power heads. Using this attachment with any other unit
could result in personal injury and damage to the unit.
WARNING:
To avoid serious personal injury and
damage to the unit, shut the unit off before removing or
installing an attachment.
INSTALLING AND REMOVING THE ATTACHMENT
Installing the Attachment
1. Remove the hanger from the attachment.
2. Align either of the two slots on the attachment with the latch on
the power head (Fig. 3). If using the nozzle, make sure it faces
forward when the unit is held in the operating position (Fig. 4).
3. Insert the attachment into the power head until the latch snaps
into place (Fig. 3).
4. Gently pull the attachment away from the power head to verify
that it is securely installed.
Removing the Attachment
1. Push the latch button down firmly and pull the attachment
straight out of the power head (Fig. 3).

ASSEMBLY

Nozzle
Attachment
6
Bump Slots
Blower Tube
Fig. 1
Unlock
Fig. 2
Latch Button
Slots
Latch
Fig. 3
Bumps
Lock
Power Head